Caterpillar wheel dozer 816 cutting edge 4T6531/4T2922/4T2923

Our aftermarket full sets of Caterpillar 816 Wheel Dozer Cutting Edge and End Bits are heavy-duty ground engaging tools specially engineered for CAT 816 series wheel dozer / landfill compactor. The Cat 816 is widely deployed in large municipal landfill sites, waste spreading & compaction, industrial solid waste yards, heavy stockpile management, large area site levelling and subgrade construction. It operates continuously under high abrasive loads from mixed waste, rubble, clay and aggregate debris, combining severe sliding friction with intermittent medium impact.

Cat 816 wheel dozer mainly suffers heavy sliding abrasion with occasional medium impact. Avoid over-hard brittle cutting edges, which chip easily upon contact with hard waste fragments.

To ensure stable quality level,our factory execute strict quality inspection during our entire process :

1. Raw material spectral test:  we will detect chemical composition for every batch, reject recycled inferior steel.

2. Hardness test: our technican will do hardness test on cutting edges and end bits for multi-point, and ensure hardness controlled at reasonable range, no local soft zone.

3. Dimension inspection: our inspector will check length, width, thickness, hole pitch, hole diameter and end bit contour, all tolerances comply with OEM drawings.

4. Bevel & profile inspection: we will check uniformity of bevel angle, and inspect cup or flat profile of end bits, ensure no forging defects.

5. Visual inspection: ensure no quenching cracks, surface scratches, deformation, burrs or cold laps.

Welcome to contact us for Caterpillar wheel dozer cutting edge and end bits, our products cover Cat 814,815,816,824,825,826,834,844 wheel dozers. Multiple bevel options for cutting edge: double bevel reversible, single bevel, square edge and carbide reinforced. End bits available in flat cut and heavy-duty cupped hot forged style.

To quote precisely, please share your wheel dozer model, OEM part numbers for cutting edge & end bits, plate thickness, required bevel type, end bit style ,we can provide material and hardness test report with stable lead time.